This voltage checker is designed for on-board use, it can be plugged to a spare slot of your receiver, to show your RX battery voltage.
Dimension: 24x20x 12 mm
Weight: 6 grams
Operating Voltage: 3V to 30V per cell
Connector type: JR, compatible with Futaba
Current consumption: 4-8mA
Wire length: 20cm
* This voltage checker only have two wires for input, and it using a JR connector for input, you can not connect it directly to a balance connector of a battery pack.
For the type which can plug directly to the balance connector of a battery pack, refer to MINIBC6S instead.
* Wrong polarity will damage the device, and not covered by warranty.
1 x voltage checker
1 x double-side adhesive
2 x screws
Messages of this section are not monitored by HiModel, it is for review and discussion among customers only.
Upload Image: (Up To 5 Files, only .jpg/.gif/.png
files are accepted and sizes below 2MB for