Features 1) Two external analog telemetry ports (A1&A2) and one digital data-stream port (Rx); 2) RSSI (PWM) and CPPM output - If CH3 and CH4 are connected by a jumper, CH1 will output CPPM for CH1~CH8, and CH2 will output RSSI (PWM); 3) When side port pins of A1 and X are connected by the jumper, A1 will change from external analog telemetry port to internal built-in battery voltage sensor; 4) Firmware upgradeable; 5) Two switchable PPM modes - FS mode and HS mode; 6) Alarm warning on low voltage, poor reception, etc.
1.1 Compatibility Compatible with FrSky two way telemetry modules: DFT, DJT, DHT, DHT-U 1.2 Specifications Dimension: 55*25*14mm Weight: 12.4g Operating Voltage Range: 3.5V-10.0V Operating Current: 100mA Operating Range: full range (>1.5km) Servo Frame Rate: 18ms (FS – Normal Speed Mode) 9ms (HS – High Speed Mode)
Includes: 1 x receiver D8R-XP
Messages of this section are not monitored by HiModel, it is for review and discussion among customers only.
Upload Image: (Up To 5 Files, only .jpg/.gif/.png
files are accepted and sizes below 2MB for