Includes:
1 x transmitter
1 x RD921 DSM2 receiver
4 x DS589 servos W/ hardware
1 x Ni-Mh 4.8V/1500mah RX battery
1 x Ni-Mh 9.6V/1500 mAh TX battery
1 x charger NEC-322 for RX & TX battery
1 x switch harness
2 x binding plug
1 x Instruction manual (English)
* Note: we only sell the radio system in complete set, and do not sell the transmitter nor other components separately, so please do not ask.
Comments:
Mode selection:
The Mode of the sticks can be chosen with the mode selection function of the radio. You can choose from Mode 1, 2, 3 or 4. The transmitter comes set to Mode 1. If Mode 2 or Mode 4 are chosen you will need to remove the back of the transmitter cover and swap the throttle ratchet and elevator spring.
(Refer to Instruction Menual page 22 for more details )
HiModel
2006/07/10
Customer Reviews:
Average Customer Review: 1 customer review(s).[Write a review/question]
A****ogud
Grade: Good night! If I get the radio Jr 9 channels you could send it already prepared for use in mode 2? Thank you for your attention? September 27 2009 Was this review helpful to you? Yes [ 0 ]
No [ 1 ] [Reply this review]
Discussion of this review:
Also need to know if you have the JR 9 Channel Radio in stock? Again Thanks! -- Sep 27 2009 by A****ogud
Please explain:
Messages of this section are not monitored by HiModel, it is for review and discussion among customers only.
Upload Image: (Up To 5 Files, only .jpg/.gif/.png
files are accepted and sizes below 2MB for
each)