Features: 

A new generation AIO Flight control for FPV, based on F303 MCU, using F3 MCU controls OSD over SPI bus in DMA mode,

OSD Configation has been incl. in Betaflight GUI.

Supports SD Card and LIPO direct input (2-4S)

MPU6000 at SPI bus.

OMNI F3 Flight Control W/ Betaflight OSD

Firmware: betaflight_3.0.1_OMNIBUS

STM32F303CCT6 MCU

SPI Sensor MPU6000

Output: 1-4 brushed motors (2.54mm Pinheaders)

OSD interface: camera input, 5.8G VTX output

Dimension: 20 x 28mm

Weight: 2.8g

Power supply: MAX 4.2V (1S Lipo)


Receiver configuration: 

When use SBUS and DSM/DSM2/DSMX receivers,  please set RX3 as input port.
DSM/DSM2/DSMX receivers take power from 3.3V.
SBUS and PPM receivers take power from 5V.

Includes:
1 x  OMNI F3 Flight Control 
1 x buzzer
1 x power cable

Please explain:
Messages of this section are not monitored by HiModel, it is for review and discussion among customers only.