The Pixhawk 6C is based on the Pixhawk FMUv6C Open Standard and Connector Standard, and comes with PX4 pre-installed. Inside, an STMicroelectronics STM32H743 is paired with sensor technology from Bosch and InvenSense, giving you flexibility and reliability for controlling any autonomous vehicle, in both academic and commercial applications.

• High-performance H7 processor with clock speed up to 480 MHz
• New cost-effective design with low-profile form factor
• Redundant inertial measurement unit (IMU) from Bosch and InvenSense
• Integrated vibration isolation system to filter out high-frequency vibration and reduce noise
• IMUs are temperature-controlled by onboard heating resistors
• Hardware-switchable 3.3V or 5V PWM signal mode (requires opening the casing)

Holybro Pixhawk 6C Flight Controller (Plastic Case)