FPV 5.8G 400mW A/V Transmitting module, a good choice for avoiding interference for customers using 2.4G radio system.
- dimension and weight is similar to 200mw TX, yet the range is extended. - compare to the 500mw version which with cooling fan installed, the 400mw version is lighter, and consuming less power (longer in-air time), also eliminated vibration to video transmitting system caused by cooling fan.
The 400mw version is a well balanced solution among weight, dimension, range, power consumption etc.
FPV 5.8G 400mW A/V Transmitter Module (TX) Transmitting unit weight: 35g (excluding antenna) video format supported: NTSC/PAL Working frequency: 5645-5945Mhz Power input: 7-15V (3S Lipo suggested, does NOT support 4S Lipo) Transmitting current: 220mA Dimension: 55*26*17mm (excluding antenna) Antenna connection: SMA jack (TX module side) Refer to here for connector type diagram
* This product shares the PCB board with the 1000mW version, you may see letters "TX51W-power...." on the PCB board, this is not a mistake. There is no cooling fan on the 400mW version which is a obvious difference. *Note: TX antenna must be installed properly before it is switched on, power on without install antenna, or a improper antenna was used may easily burn the TX, and such damage is not covered by warranty.
Includes: 1 x transmitting unit (TX) 1 x TX antenna (2db) * No instruction manual supplied with this product.
Requires: 1 x receiving unit (RX)
Primary Additional Accessories for the completion of the FPV 5.8G 400mW A/V Transmitter Module (TX) ｜SMA, jack
Messages of this section are not monitored by HiModel, it is for review and discussion among customers only.
Upload Image: (Up To 5 Files, only .jpg/.gif/.png
files are accepted and sizes below 2MB for