BGC 2-axis/ 2-axle Brushless Gimbal Controller - Large Current Edition
- With latest official V3.11 firmware - Adopts MOSFET replacing L6234D, provids higher driving power. - Spare IIC port can connect to expansion board directly, no jump wire is needed. - Can work at 5A continuously (heat sink is suggested in this case), and peak current up to 10A. - Firmware upgrading is supported when newer official version firmwares available
BGC 2-axis/ 2-axle Brushless Gimbal Controller - Large Current Edition | V3.11 (Firmware upgradeable)
Weight: 15g (including sensor and wire) Main board size: 50 x 50mm Continuous working current: 5A (when work at 5A continuously, heat sink is highly recommended) Peak current: 10A Power input: 3-4S （ 12V/ 3S is highly suggested) Supported motor size: 2 to 8 series (motors for cameras from Gopro to Red Epic)
* Do bench test and monitor the MOSFET temperature of your system when use 4S Lipo battery.
1 x GBC Universal Brushless Gimbal Controller main board, large current edition 1 x sensor 1 x connection wire
Messages of this section are not monitored by HiModel, it is for review and discussion among customers only.
Upload Image: (Up To 5 Files, only .jpg/.gif/.png
files are accepted and sizes below 2MB for