Input voltage:2.5-25V
Output voltage:3-25V adjustable
Input current: 4A (max) when input voltage is above 3V; peak 5A (less then 10 seconds)
Efficiency:Max 95%
Working temperature: -40℃ to +85℃ (when temperature is above 40℃, heat sink must be applied)
Output ripple:
Input 3.7V output 5V 2A ripple 40mV
Input 5V Output 12V 0.5A ripple 25mV
Input 5V Output 12V 1A ripple 40mV
Input 5V Output 12V 1.5A ripple 60mV
Input 12V Output 24V 1A ripple 80mV
Wrong polarity protection: No, wrong polarity will burn the PCB directly.
Low voltage protection: Yes (when low voltage protection is activated, the output voltage will be equal to input voltage)
Short circuit protection:No
Weight: 6.7g
Size: 3x1.8x1.3 cm
*This device is specially introduced to those experienced DIYers, basic electronic knowledge and DIY/welding skills are required, we are not responsible for damages due to lack of welding skills or wrong wirings etc.
*Check the output voltage and adjust the virable resistor to adjust the voltage if needed before connect to your device.
Includes/Requires:
Includes:
1 x voltage regulator
* Wires are not provided, customers need to weld the input and output wires yourselves, so basic welding skills are required, also wrong polarity will cause severe damage to the unit.
Customer Reviews:
Average Customer Review: 2 customer review(s).[Write a review/question]
F****enheit-145
Grade: This is a STEP UP CONVERTER!! Not a Voltage-Checker...
I put in this in Security-Lamps with only 1 LiIon Cell to step up the Voltage to 14,3V for the LED´s lightning stronger.
If the Voltage falling lower than 2,6V the LED´s are flashing verry fast.
This you cannot take for LiPo they will destroyed while Low Cell voltage.
Also you can Take LiFepo because lower than 2.4V Converter stops working.
For stability and the Price I give 5 Stars
Peter June 20 2013 Was this review helpful to you? Yes [ 0 ]
No [ 0 ] [Reply this review]
t****an
Grade: Not tested yet.
How we will be able to activate low voltage protection and how set the cut-off voltage ? any coment, or any info HiModel ? April 07 2011 Was this review helpful to you? Yes [ 0 ]
No [ 3 ] [Reply this review]
Discussion of this review:
no low voltage protection... you should build a voltage supervisor circuit or decide to use a "Low Voltage Buzzer for 2S/3S/4S Lipo Battery" in addition. This circuit is only a switch mode PS -adapter. -- May 23 2011 by t****an
Please explain:
Messages of this section are not monitored by HiModel, it is for review and discussion among customers only.
Upload Image: (Up To 5 Files, only .jpg/.gif/.png
files are accepted and sizes below 2MB for
each)