Pixhawk Multi-mode Open Source Autopilot Flight Controller | V2.43

Fly control version: PIX2.43 
Main board dimension: 82 x 43 x 17mm

* GPS module is NOT included, to be purchased separately. 

Special hint:  When the APM main board is connected to your computer via USB connection, all other peripheral devices must be disconnected, otherwise it may cause overheat and burn out to the main board, and such damage is NOT covered by warranty.  When you need to connect peripheral accessories, the USB connection to computer must be removed.
 

Includes: 
1x Pixhawk autopilot main board with case
1 x 10S current sensor
1 x Buzzer
1x Safety switch button
1x  TF card reader
1 x I2C distribution board
1 x Miscro USB cable
1 x wire set


Requires:
1 x GPS (with compass)

Please explain:
Messages of this section are not monitored by HiModel, it is for review and discussion among customers only.