This is the DN Power balance charging extension for G3 charger(also called Cascade Charging Dock), you can plug up to 6 packs to the extension, and the extension will charge all packs connected to it one by one automatically without manual interference.

Size: 142 x 85 x 31mm
Weight: 427g / 15.061oz

* This extension is designed for DN Power G3 charger only, and can not be connected to other chargers nor power sources except the DN Power G3, damages of doing so will be at customer's risk.
* Balancing output ports are compatible with HiModel series batteries, you can plug the balance tap of HiModel batteries directly to the charging extension, no polarity reverse cables are required.

Includes:
1 x extension for DN Power G3 charger
1 x DC power source cable
1 x 6S balance charging connector (charger to extension)

HiModel Note:
The 6No. output ports are all for 6S Lipo batteries, when charge batteries less than 6S, you can use a 6S to 5S/4S/3S/2S/1S convert cable (not included) or just simply cut off one of the rib on battery balance connector, then you can plug a 5S/4S/3S/2S/1S pack directly to the 6S port of the extension.

Trouble shooting:
When use the G3 extension , the charging mode must be set to PA0.

There is a delay about 4-5 seconds once you press Start/Stop till the EX-6 to respond, so please be patient once you press Start.

Please explain:
Messages of this section are not monitored by HiModel, it is for review and discussion among customers only.