* Large graphic liquid-crystal display panel with 4 buttons and easy set up trun-and-press Dial for quick, easy setup.
* All transmitters include all 3 aircraft types with specialized programming for each, including:
- Airplane (ACRO)
--Twin Aileron Servos (FLAPERON AND AIR-DIFF)
--Twin Elevator Servos (AILEVATOR)
--Snap Roll ( 4 separate directions available)
-Helicopter (6 swashplate types, including CCPM)(HELI)
--3 Idel Ups
--Throttle and Pitch Curvers per Condition
--Gyro Mixing including separate settings per condition
-Sailplane/Glider (3 wing types)(GLID)
--Twin ailerons (FLAPERON and AIL-DIFF)
-- 4 flight conditions (NORM/OFFSET-1/2/3)(GLID2FL-C Only)
*BASIC menu for quick, easy set up of less complex models.
*ADVANCE menu for more complex, unique setups.
*Four electronic Trim Levers for rapid yet precise trim adjustment - no remembering to "store trims" between models and no more "bumped trims" during transport.
*IDLE-DOWN (ACRO) and THR-CUT (ACRO/HELI) (engine shut off) setups to allow precise engine control for taxi and landings.
*12 complete model memories with 6 more per optional CAMPac.
*New stick design with improved feel, adjustable lenght and tension.
*Triple rates available by setting dual rates to 3-position switches.
*Eight Switches, 3 Dials and 2 Sliders; compeletely assignable in most applications.
*Trainer system includes the "functional" (FUNC) setting, which allows the student to use the 9C super's mixing, helicopter, and other proramming functions even with a 4-channel buddy box.
*Transmits in both FM(PPM) and PCM by selecting modulation/cycling transmitter. Requires receiver of proper modulation.
*Permanent memory storage via EEPROM with no backup battery to service or have fail.
*It features helicopter-friendly switch layout, with idle-up and throttle hold switches at the left hand, and a smooth, ratchet-less (unsprung) throttle for perfect hovering. Defaults to HELI(SW1) MODEL TYPE.
*Change transmitter mode from mode 1 to modes 2,3 or 4.
Type: R319DPS synthesized
Receiving frequency: 35Mhz
Intermediate frep.: 10.7Mhz & 455 kHz
Power requirement: 4.8V Ni-Cd battery
Current drain: 40 mA
Size: 1.27 x 2.17 x 0.80 in. (32.2 x 55.2 x 20.3 mm)
Weight: 1.25 oz. (35.5 g)
One Tx 9CAP-PCM (Only Model 1 available - throttle on right hand, but you can change it to Model 2 by yourself.)
One Tx RF Synthesized Frequency Module FP-FSM
One Rx FP-R319DPS Synthesized Rx (Dual Conversion, PCM1024)
One RX Battery 600mAh
One Tx Battery NT-8S700B 700mAh
One Charger FBC-18C(4) (220V two round plug)
One Mini switch harness with charge cord
One Instruction manual ( English )
One Tx Antenna
Three S3001 Futaba servos
we only sell the radio system in complete set, and do not sell the transmitter nor other components separately, so please do not ask.
Messages of this section are not monitored by HiModel, it is for review and discussion among customers only.
Upload Image: (Up To 5 Files, only .jpg/.gif/.png
files are accepted and sizes below 2MB for