Matek Multi-rotor X-shape Power Distribution Board W/ 5V/ 12V outputs, Current Sensor, OSD (XT60 Connector) STOSD8
    SKU HUBOSD8-X
    Manual Manual 1
    Added 2017/02/15
    Updated 2017/02/15
     
    Tags: Matek  Multi-rotor  X-shape  Power  Distribution  Board  W  5V  12V  outputs,  Current  Sensor,  OSD  (XT60  Connector) 

    Features:

    The HUBOSD8 has been engineered to provide the highest possible performance and reliability in a 46*36mm & 4 layers PCB.  It is a multifunctional HUB with PDB, BEC 5V/2A &12V/500mA, Current sensor 140A, STOSD8. It is specially made for the mini FPV Quad.  The BEC 12V is linear regulator, no LC Filter needed. Built-in STOSD8 can support Plug & Play, no complicated settings needed.

    Specifications:

    Matek Multi-rotor X-shape Power Distribution Board W/ 5V/ 12V outputs, Current Sensor, OSD (XT60 Connector)

    General

    Input voltage range (3S-5S operation): 8 - 21VDC
    PDB: 4x30A (Max.4x35A)
    Regulated 5V and 12V outputs
    Current Sensor 140A Built-in STOSD8
    Physical:
    - 2oz copper, 4
    -layers &1.6mm PCB.
    - 1x Battery input, 4x ESC outputs.  2x BEC 5V outputs, 2x BEC 12V outputs.
    - Camera signal & Gnd pads, Video Transmitter Signal & Gnd pads
    - 1x Serial port (RX, TX, G)
    - Dimensions: 51x36x4mm, Weight: 9g
    - Mounting holes 30.5mm square spacing,Φ3mm

    PDB (ESC output)


    Continuous current: 30A per output
    Peak current (10 seconds/minute): 35A per output

    BEC 5V output

    Designed for RC Receivers, Flight controllers, OSD, and Servos.
    DC/DC synchronous buck regulator.
    Voltage: 5.0 +/- 0.1VDC
    Continuous current: 2 Amps (Max.2.5A 10s/minute)
    Output Ripple: 40mV (VIn=16V, VOut=5V@2A load)
    Short-circuit tolerant (5 seconds/minute)


    BEC 12V output

    Linear regulator, very low noise. LC Filter is needless.
    Designed for Video TX or FPV camera.
    Voltage: 12.0 +/- 0.3VDC (4~5S operation)
    Continuous current: 500mA@16V IN,  400mA@20V IN
    Short-circuit tolerant (2 seconds/minute)
    If the battery is 3S LiPo,  Output voltage=3S LiPo voltage - 1V

    Current Sensor

    140A
    If current >140A. STOSD display 140A

    Includes/Requires:

    Includes:
    1 x Matek Multi-rotor X-shape Power Distribution Board W/ 5V/ 12V outputs, Current Sensor, OSD (XT60 Connector)
    Back to computer version.
          Back
    Loading...