Microprocessor controlled high-performance rapid charger/discharger for NiCd/NiMH/Li-poly/Pb batteries with cell voltage balancer.
●Voltage balancer for Li-polymer battery
BC has an individual-cell-voltage balancer inside. So it does not need any balancer separately when charging Li-poly battery for cell balancing.
●Maximum safety
Delta-peak sensitivity: The automatic charge termination program works on the principle of the Delta-peak voltage detection.
Capacity limit: The charging capacity always calculated b multiple of the charging current and time. If the charging capacity exceeds the limit the process will be terminated automatically when you set the maximum value.
Processing time: you can also restrain the maximum process time to prevent from any possible defect.
Input power monitor: To protect the car battery using as input power from being damaged the voltage of it always monitored. If it drops below the lower limit the process will be ended automatically.
●High-power and high-performance circuit
BC emplyes the circuit that has mximum output power of 50W. As a result it can charge or discharge up to 14 cells of NiCd/NiMh and 5 series of Li-poly batteries with maximum current of 5.0A.

●Operrating voltage range: 11.0-18.0 Volt (Note: Make sure the input voltage is not higher than specified voltage, especially when you use a DC adaptor, please measure the voltage before connect it to the charger, chargers damaged due to high input voltage are not covered by warranty.)
●Ccircuit Power: max. 50W
●Charge current range: 0.1-5.0A
●Current drain for balacing Li-po: 200mA/cell
●NiCd/NiMh batter cell count: 1-14 cell
●Li-ion/Polymer cell count: 1-5 series
●Pb battery voltage: 2 to 12V
●Weight: 350 g
●Dimension: 130 x 90 x 28 mm

Drivers and software

Includes:
1 x 601BC charger
1 x USB cable
1 x DC clamp
1 x multifunctional extension wire
1 x Igniter plug
1 x JST plug
1 x DuPont plug for receiver
1 x English manual
1 x CD disk

Requires:
10-18V DC power source

*Connector compatible with all HiModel Lithium Polymer battery packs.
* This charger does not have temperaturer sensor interface, and also no temperaturer sensor provided with the charger.

HiModel
12/14/2006

Please explain:
Messages of this section are not monitored by HiModel, it is for review and discussion among customers only.