HiModel-60 AS Series Brushless Motor Speed Control
    SKU HM-60A
    Brand HiModel
    Manual Manual 1
    Added 2005/12/24
    Updated 2007/03/06
     
    Tags: HiModel-60_AS_Series_Brushless_Motor_Speed_Control 

    Features:

    * High rate (10 KHz) switching (PWM)
    * 3 to 6 Li-poly cells.
    * Powerful direct-drive ability (High-torque drive ability).
    * Smooth Linearity of throttle.
    * Dynamic braking ensures prompt prop folding.
    * BEC (2.0A) provides power to receiver and servos -eliminates separate receiver battery.
    * Over temperature protection.
    * User Programmable Features.
    * Low-voltage protection.
    * Cutoff can be programmed for motor stop or reduced power.
    * Brake Type selectable.
    * Throttle Range.
    * Timing Advance:4 to 10 degree, 10 to 20 degree, 20 to 30 degree to suite different magnet poles motors.
    * Safe "power on" arming program ensures motor will not accidentally turn on.
    * Low torque "soft start" prevents damage to fragile gearboxes.
    * Lost single protection: Auto shut down in 4 sec after signal is lost or radio interference becomes severe.
    * Microprocessor controlled.
    * PC connection and set up via PC enabled, you can even test your power system via PC software desinged for the ESC.
    * Change the rotation by programming
    * Motor Jam Protect: When motor jam normally make the ESC broken, HiModel's powerful hardware and software design can protect the ESC not be hurt.
    * Over heat protection: ESC will cut-off when temperaturer is higher than 155 degree.
    * Over voltage protection.


    For more featurers, please visit here.

    Specifications:

    MODEL:HM-60A
    CURRENT: 60amp
    SURGE: 80amp
    BEC: 2amp ( BEC can only be used under 3S or lower, the BEC function MUST be disabled when use under 3S Lipo above)
    SIZE:5.2cm*2.8cm*1.3cm
    WEIGHT (WITH WIRES): 45g

    Download the PC Software here

    Download USB Driver here



    Comments:

    BEC function of the ESC can only be used under 3S or lower, the BEC function MUST be disabled when use with 3S Lipo above by removing the middle red wire of the signal wires of the ESC,otherwise will cause burnt of the BEC elements, you need a separate external UBEC unit or battery pack to power the servos.

    HiModel
    Back to computer version.
          Back
    Loading...