X-CAM 2 Axis Gimbal Stabilization Module GSM110
    SKU GSM110
    Added 2013/04/12
    Updated 2018/07/12
     
    Tags: X-cam,  X-cam  tech,  gimbal  stabilization  module 

    Specifications:

    X-CAM 2 Axis Gimbal Stabilization Module GSM110
    Specification:


    Input Voltage: 5 
    - 6V

    Volume: 45 x 35 x 10 mm


    There are 4 versions of this series product available

    1. 2 Axis Stabilization:  GSM110, GSM210

    2. 3 Axis Stabilization:  GSM120, GSM220

    And this one is version GSM110.



     How to use the Remote Controller for Servo Reverse Setup :

    1.  Connect to channel CH5 on the Printed Circuit Board (PCB)

    2.  Push this channel to the highest position on your Remote Controller

    3.  There will be 3 BEEPs followed by the Red LED flashing, Return the Remote Controller Lever to the middle position to enter the Servo Reverse Setup mode

    4.  Move the Remote Controller Lever to the Highest or lowest position to set the Servo Reverse after hearing the BEEPs.
         (One BEEP means Channel 1 (TILT) , Two BEEP means Channel 2 (ROLL), Three BEEP means Channel 3 (PAN) ), 
         If you do not want to change the setup, Just move the  Remote Controller Lever to the Middel position.

    5.  When you hear 4 BEEPs, the setup has been saved.

    How to adjust the Acc. Gain:

      Rotate the Blue Potentiometer on the PCB for adjust the Acc. Gain.

    PC software for setup



    Includes/Requires:

    Includes:
    1 x Gimbal Stabilization Module
    1 x USB cable
    1 x double-side adhesive pad

    * Download PC software here.




    Back to computer version.
          Back
    Loading...