IFLIGHT 3-Axis CNC gimbal (for SONY 5N,RX-100,BMPCC etc.)
    SKU IFT-3A
    Brand IFLIGHT
    Added 2015/06/08
    Updated 2015/06/08
    Tags: IFLIGHT  3-Axis  CNC  gimbal  (for  SONY  5N,RX-100,BMPCC  etc.) 


    IFLIGHT Upgraded 3-axis CNC Aerial Gimbal for SONY 5N,RX-100,BMPCC Camera Easy Gimbal brushless made by aluminum with vibration dampener on the top alloy and make the gimbal to light, rigid, fast and without gaps.


    •Support Sony NEX5/7,RX-100,BMPCC and other micro -SLR camera
    •Support 18-55mm lens
    •Ready to Use with 32BIT alexmos Simple BGC
    •Support sensitivity parameter adjustment and software 3D pose display
    •Support rocker rate mode and position mode
    •Aluminum alloy,half arm frame,sturdy and lightweight
    •Adjust the focus with the camera,can be adapted to different lens
    •Active augmentation technology,closed-loop monitoring and control,more accurate compensation augmentation
    •Full adjustable mechanism is designed to allow a perfect balance adjustment to get the best of the best performance


    IFLIGHT 3-Axis CNC gimbal (for SONY 5N,RX-100,BMPCC etc.)

    Support Receiver:condditional receiver、PPM receiver, DSM2/DSMJ/DSMX receiverSupport Remote Controller Equipment:PPM/PCM/2.3G
    Operating Voltage:DC 7.4V~14.8V (Recommand11.1V,3pcs Li-po battery)Operating Current:200mA-2A
    Working Enviroment Temperature:-15℃~65℃Processor:MEGA328P Processor
    Sensor:MPU6050 3-axis Gyro、AccelerometerMAX Angular Rate :2000°/SEC
    Max Acceleration:16gControl Freqency:1600Hz
    Motor Driver Frequency:8/32KHz(Noise power saving driver/No noise smooth driver)Control accuracy:0.1°
    Control Angle Range:-45°~45°(roll), -90°~90°(pitch)Gimbal controller board:iFlight ALEXMOS genuine 32-bit Gimbal controller board(2.43b6)
    Motor:iPower GBM4108H-120T motorGimbal+Controller+Shockproof Board Net Weight:564g


    1x3 axis brushless camera gimbal (ready to use)

    * This is the gimbal only,  Camera or drone are NOT included.
    Back to computer version.