FPV 5.8G 400mW A/V Transmitter Module (TX) TS353|RP-SMA, jack
    SKU TS-353
    Added 2013/04/08
    Updated 2015/09/15
    Tags: video  recording  system,  FPV 


    FPV 5.8G 400mW A/V Transmitting module, a good choice for avoiding interference for customers using 2.4G radio system.

    - dimension and weight is similar to 200mw TX, yet the range is extended.
    - compare to the 500mw version which with cooling fan installed, the 400mw version is lighter, and consuming less power (longer in-air time), also eliminated vibration to video transmitting system caused by cooling fan.

    The 400mw version is a well balanced solution among weight, dimension, range, power consumption etc.


    FPV 5.8G 400mW A/V Transmitter Module (TX) 
    Transmitting unit weight: 25g (excluding antenna)
    video format supported: NTSC/PAL
    Working frequency: 5645-5945Mhz
    Power input: 7-15V (3S Lipo suggested, does NOT support 4S Lipo)
    Transmitting current: 220mA
    Dimension: 55*26*17mm (excluding antenna)
    Antenna connection: RP-SMA  jack (TX module side)   Refer to here for connector type diagram

    *Note: TX antenna must be installed properly before it is switched on, power on without install antenna, or a improper antenna was used may easily burn the TX, and such damage is not covered by warranty.


    1 x transmitting unit (TX) TS353
    1 x TX antenna (2db)
    * No instruction manual supplied with this product.

    1 x receiving unit (RX)
    Back to computer version.