- Super soft and thin silicon wires, extremely low resistance to gimbal movements.
4-Pin 50CM Sensor Cable for BGC Series Gimbal Controller
Wire type: super soft silicon wire
Wire length: 50cm (approx.)
Pin distance: 1mm
Connector pin numbers: 4-pin to 4-pin
Suitable controllers: BGC series or other controllers using same connectors.
Hint: Due to the design of I2C protocol, it doesn't suit for using long wires, when use this cable, it is suggested to increase the I2C signal level to increase the communication stability as shown in below diagram.
1 x sensor cable